Direkt zum Inhalt

Crazy Advanced Support

FAQ - Adrenalineshocker

Adrenaline Shocker Questions

How do I swap between electro and mech?

Öffnen

We've prepared a video walk-through for this procedure. Use the same steps either as listed in the video or, if converting the opposite direction, in reverse.

Check out the Video on our YouTube channel.

How to I swap the mid-rise and low-rise?

Öffnen

We've prepared a video walk-through for this procedure. Use the same steps either as listed in the video or, if converting the opposite direction, in reverse.

Check out the Video on our YouTube channel.

How do I set up the timer?

Öffnen

To set up the timer (and to learn some great tips to improve its usability) check out our Blog Post about it.

What is the ideal operating pressure?

Öffnen

The ideal tank output operating pressure for an Adrenaline Shocker is around 650 psi. If you purchased a 1st generation Adrenaline tank (with a Ninja regulator) from us, they were pre-set for Adrenaline Shockers.

Note: Adrenaline Shockers can operate at higher or lower output pressures so if your tank is set to 450 psi or 750 psi, as an example, it should perform just fine.

How do I get the electronic trigger to pivot freely?

Öffnen

A common issue we see is the electronic trigger will either stick in the pulled position or pivot in a rough manner. These issues may be easily resolved by loosening the trigger pivot pin screw (1/16" key) a slight amount (usually 1/4 turn or less).

How do I know if I have factory anodizing or a re-anodized Uncommon?

Öffnen

If you do not have an Adrenaline serial number lasered on the upper left side of each grip frame then it has likely been re-anodized. We do not ship units without serial numbers. If there is a dash/hyphen between the Adrenaline "A" logo and the serial number, it has been re-anodized (by someone) and then re-lasered by us.

How do I get the vision eyes to work again?

Öffnen

If your vision eyes stop working it is usually resulting from a pinched vision harness wire. Check to ensure no wires are pinched. If they are pinched and freeing them up does not fix the issue, you may need to order a new vision harness from Shocker Paintball.

What grease should I use and when?

Öffnen

We only recommend the Shocker Paintball factory grease that is included in your Adrenaline Shocker case. You may order additional grease from your favorite Shocker dealer.

Any questions as to whether X, Y or Z grease will void the marker warranty should be directed to Shocker Paintball.

With regard to frequency, the routine referenced in the Shocker manual is fine. However, due to the low friction coefficient of the ICE coating on the Adrenaline bolt and can vs. the uncoated factory Shocker coating, you are able to go longer between grease treatments if desired.

What should I use to clean and polish?

Öffnen

Do not use all purpose cleaners such as Simple Green on your Adrenaline Shocker. We recommend a dry microfiber or, in dirty situations, water and a microfiber. Then you may follow up with a high quality polish and a high count microfiber. Adrenaline offers both Anodizing Polish and a Polishing Microfiber.

Schließen (Esc)

Popup

Use this popup to embed a mailing list sign up form. Alternatively use it as a simple call to action with a link to a product or a page.

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.

Suchen

Zum Warenkorb hinzugefügt